Confined Space 4 Gas Monitor
Description: 72-RA-C – GX-3R for LEL / O2 / H2S /CO with Li-on battery pack and 100-240 VAC charger
Features
- Smallest & lightest 4 gas monitor
- 2.2″ W x 2.55″ H x 1.02″ D, 3.52 ounces
- Simultaneous detection of 4 gases
- LEL, O2, H2S & CO
- H2 Compensated CO sensor available
- Simple 2-button operation
- Non-Compliance Indicator
- Alarms: audible, visual, & vibration
- 3 user adjustable alarm levels
- 25 hours of operation (Lithium-ion battery)
- Water and dust resistant design, IP66/68
- 3 Year warranty
Description
OSHA defines the breathing zone as a ten inch radius around the worker’s nose and mouth, and requires that worker exposure monitoring air samples be collected in the breathing zone. Air sampling filters may be attached to the collar or lapel. Traditionally this means only a single gas monitor would be small enough for a worker to practically wear a gas monitor ‘In the breathing zone’. Now there is a 4 gas monitor smaller than many single gas monitors.
The GX-3R is the worlds smallest 4 gas monitor weighing only 3.52 ounces and can comfortably be clipped within a worker’s breathing zone (2.2” W x 2.55” H x 1.02” D). It simultaneously monitors and displays LEL combustibles, O2, CO (Hydrogen compensated CO also available), and H2S.
The GX-3R by RKI Instruments represents the latest evolution of gas detection technology utilizing a new generation of micro sensors. The LEL sensor has a unique design with two active filaments in one sensor to increase it’s resistance to silicone poisoning. If one filament gets poisoned the second filament takes over. The new O2 sensor is electrochemical with a 3 to 5 year life span. H2S and CO are now available in a combo micro sensor.
Safety supervisors will appreciate the non-compliance indicator. The instrument flashes it’s 3 LED lights every 30 seconds in the following conditions; if the instrument has not been bump tested, or if calibration is due, or if there was a gas alarm event. The 3 LED lights will continue to flash once every 30 seconds until the non-compliance condition has been resolved. The 30 second interval is adjustable.
| Gas Detected |
(CO) |
Carbon Monoxide(CO) | Hydrogen Sulfide(H2S) | H2S Only |
Combustible Gases |
Oxygen
|
|||||
|
Dual Sensor |
|||||||||||
| Sensor Slot |
1 |
2 |
3
|
||||||||
|
Detection |
EC | Dual EC | EC |
Catalytic combustion |
EC
|
||||||
| Detection Range (Increments) |
0 ~ 2,000 ppm |
0 ~ 200.0 ppm (0.1 ppm) |
0 ~ 100% LEL |
0 ~ 40% Vol. (0.1%)
|
|||||||
| Accuracy Statement |
± 5% of reading |
± 5% of reading or ± 5 ppm CO (whichever is greater) |
± 5% of reading or ± 2 ppm H2S (whichever is greater) |
± 5% of reading |
± 5% of reading O2
|
||||||
| Sampling Method |
Diffusion sampling standard (hand aspirator or clip-on motorized pump optional) |
||||||||||
| Display |
Digital LCD displays with 7 segment plus 14 segment plus icon |
||||||||||
| Preset Alarms (User Adjustable) Overscale alarm (Non-adjustable) |
1st alarm: 25.0 ppm 2nd alarm: 50.0 ppm 3rd alarm: 1200.0 ppm TWA alarm: 25.0 ppm STEL alarm: 200.0 ppm Over alarm: 2000.0 ppm |
1st alarm: 5.0 ppm 2nd alarm: 30.0 ppm 3rd alarm: 100.0 ppm TWA alarm: 1.0 ppm STEL alarm: 5.0 ppm Over alarm: 200.0 ppm |
1st alarm: 10% LEL 2nd alarm: 25% LEL 3rd alarm: 50% LEL Over alarm: 100% LEL |
||||||||
| Types of Alarms | Gas Alarm: 3 Increasing alarms, STEL, TWA, overscale alarm. O2 decreasing/increasing. Trouble alarm: Sensor disconnection, low battery, circuit error, calibration range error |
||||||||||
| Display of Alarm | Gas Alarm: Flashing LEDs, continuous buzzer (100 db @ 30 cm), flashing gas value, vibration Trouble alarm: Flashing LEDs, intermittent buzzer (95 db @ 30 cm), display of error message |
||||||||||
| Operating Temp. & Humidity |
-20°C ~ +50°C [ -4°F ~ +122°F ], 10 to 90% RH, non-condensing (continuous environment) -40°C ~ +60°C [ -40°F ~ +140°F ], 0 to 95% RH, non-condensing (temporary environment, 15 minutes) |
||||||||||
| Response Time | Within 30 seconds (T90) | ||||||||||
| Power Source | Lithium-ion battery, Approx. 25 hours after a 3 hour full charge | ||||||||||
| Approvals | ATEX, CSA | ||||||||||
| Dimension & Weight |
2.2” W x 2.55” H x 1.02” D (Approx. 58 W x 65 H x 26 D mm), 3.52 ounces (approx. 100 g) without rubber booth 2.4” W x 2.63” H x 1.06” D (Approx. 61 W x 67 H x 27 D mm), 3.70 ounces (approx. 105 g) with rubber booth |
||||||||||
| Case Material | Explosion proof, dust and water resistant to IP-66/68 (2m,1h) approval. Drop height 23 ft | ||||||||||
| Controls | Two buttons: POWER / MODE, AIR | ||||||||||
| Datalogging | Logs user ID, station ID, Calibration & Bump Test history, Alarm Events & Alarm Interval Trends | ||||||||||
| Standard Accessories |
Alligator clip, protective rubber boot, charger, and calibration adapter | ||||||||||
| Optional Accessories |
SDM-3R calibration station RP-3R Clip-on sampling pump with 4” rubber nipple, 10’ hose and probe (up to 40’ hose available) Padded carrying case for GX-3R and accessories USB to IrDA downloading cable for datalogger |
||||||||||
| Warranty | Three years material and workmanship | ||||||||||
Professional packing and fast shipping
Because of our long-standing partnership in a long-standing partnership with UPS, FedEx, DHL and many other top global carriers we can offer a variety of shipping options. Our warehouse personnel will pack each item according to our strict specifications. Before shipping your items will be thoroughly examined and secured. We deliver to thousands of clients each day across multiple countries. This is a testament to our dedication to being the largest online retailer worldwide. We have distribution centers and warehouses in Europe and in the USA.
Note: Orders containing more than one item will be assigned a different processing period for each item.
Before shipping before shipping, we'll conduct a thorough inspection of the items you've ordered. Currently, most orders are shipped within 48 hours. Delivery is expected to take between three and seven days.
Returns
Due to multiple parties which include the factory as well as the warehouse, we are unable to completely manage our stock. The actual inventory can change at any moment. Be aware that it is possible for your order to run out of stock even after you have made the order.
Our policy lasts thirty days. However, if the 30 days have elapsed from the date you purchased the item, we cannot give you a refund or exchange.
The item you purchase must be in its original packaging and not be used. The item must be in its original packaging.
Related products
Uncategorized
Uncategorized
Uncategorized
Beacon 800 Eight Channel Wall Mount Controller by RKI Instruments Russmill Bahamas Limited
Uncategorized
Uncategorized
Beacon 110 Single Channel Wall Mount Controller by RKI Instruments Russmill Bahamas Limited
Uncategorized
Uncategorized
Uncategorized
Beacon 410A Four Channel Wall Mount Controller by RKI Instruments Russmill Bahamas Limited
Uncategorized
Uncategorized
